-
- Soil & Rock Testing Equipments
Proctor Penetrometer Set
- MODEL: QCC-ST-019 ASTM D 1558 The instrument consists of a needle attached to a spring loaded plunger, the stem of which is calibrated to read 0 to 40 kg division. Long stem is graduated at every 12.5mm to read depth of penetration and for use with needles of larger areas. The small penetration stem is also graduation in 12.5mm division…
- Read more
-
- Soil & Rock Testing Equipments
Pycnometer Bottle
- MODEL: QCC-ST-032 As Per IS 2386 (P-III) Specification : Specific Gravity is the ratio of the weight in air of a given volume of a material at a standard temperature to the weight in air of an equal volume of distilled water at the same stated temperature. The Pycnometer Bottle can be used to test a wide range of materials…
- Read more
-
- Soil & Rock Testing Equipments
Relative Density Apparatus
- MODEL: QCC-ST-038 IS 2720 (PART XIV), ASTM D 4253 & ASTM D 4254 The equipment is used for the determination of the relative density of cohesion less free draining soils and meets the essential requirements. Specification : The equipment consists one each of: Vibratory table, with a cushioned steel vibrating decks about 75cm x 75cm. It has a frequency of…
- Read more
-
- Aggregate Testing Lab Equipments, Soil & Rock Testing Equipments
Rotap Sieve Shaker
- MODEL: QCC-ST-088, 089 'ROTAP' Sieve Shaker (QCC-ST-088) To make process of sieving simpler and quicker, Rotap sieve shaker is useful , this produces circular shaking of the sieves. At the same time the sieves are tapped. The mechanism for imparting circular action and topping is oil immersed in a tank and in motorized. The shaker can accommodate upto 7 nos.…
- Read more
-
- Soil & Rock Testing Equipments
Sand Density Cone Apparatus
- MODEL: QCC-ST-027 ASTM D1556, AASHTO T191 The Sand Density Cone and accessories are used for determination of the insitu (in-place) density of soils. The apparatus is restricted to tests in soils containing particles not larger than 2" (50.8 mm) in diameter. The Sand Density Cone consists of a double cone assembly with a brass valve and comes supplied with a…
- Read more
-
- Soil & Rock Testing Equipments
Sand Equivalent Test Kit
- MODEL: QCC-ST-013 ASTM D 2419, AASHTO T 176 Used to determine the relevant proportions of clay-like or Plastic fines and dust in granular soils & fine aggregate Consists of: 1. Acrylic graduated cylinder (4 nos.) 2. Rubber stopper for cylinder (4 nos.) 3. Graduated Steel rule 450 mm 4. Funnel 100 mm plastic 5. Aspirator bottle 5 lts plastic with rubber cock 6. Stand for the…
- Read more
-
- Soil & Rock Testing Equipments
Sand Pouring Cylinder
- MODEL: QCC-ST-026 As Per IS 2720 (P-XXVIII) BS 1377-9 Specification : The soil testing equipment is used for determination of the dry density of compact, fine, medium grained soils and for layers not exceeding 50cm thickness. A circular hole is dug into the ground, all the soil from within it collected, weighed and dried, and the hole back filled with…
- Read more
-
- Soil & Rock Testing Equipments
Shrinkage Limit Set
- MODEL: QCC-ST-002 IS 2720 (PART-VII) ASTM D 427, BS 1377, AASHTO T 92. Shrinkage limit is the maximum water content at which a reduction in water content does not cause an appreciable reduction in volume of the Soil Mass. At shrinkage limit, on further reduction in water, air enters in to the voids of soils and thus keeps the volume…
- Read more
-
- Soil & Rock Testing Equipments
Soil Cone Penetrometer
- MODEL: QCC-ST-004 IS 2720 (PART IV) For determining the liquid limit of soils. This is specially useful to obtain reliable and accurate results of those soil which have low plasticity index. The percentage moisture contents determined when cone with half angle for 15-30 minutes under a total sliding weight of 148 gm penetrates 25mm gives the liquid limit. Contact…
- Read more
-
- Soil & Rock Testing Equipments
Soil Hydrometer
- MODEL: QCC-ST-005 ASTM D 422 AASHTO T 88, BS 1377-2. Used for grain size analysis of soils where more than 10% of the material will pass through 75 microns B.S. sieve. Manufactured from clear transparent glass having uniform clarity throughout the upper end on which density scale is engraved. The scale range is 0.995 to 1.030 0 density (gms./cc) at…
- Read more
-
- Soil & Rock Testing Equipments
Speedy Moisture Meter
- MODEL: QCC-ST-023 As Per IS 2720 (P-II), ASTM D 4944 AASHTO T 217 Specification : Moisture content of soil is generally measured as a ratio of the weight of water to the weight of solids, expressed in percentage. As soil behavior depends on its moisture content, it is one of the basic parameters defining the soil condition. The 'Moisture' content…
- Read more
-
- Aggregate Testing Lab Equipments, Soil & Rock Testing Equipments
Standard Test Sieves 20cm Dia.
- MODEL: QCC-ST-093 IS :460 (Par t-I, II) 1978 Test Sieves is a common laboratory requirement. Sieves are used for sieving of chemical powders, medical powders, aggregate, sand soil and cement etc. These sieves are manufactured as per various standards like IS, BS, ASTM, DIN etc. In Civil Engineering it is a common practice to use sieves for gradation and particle…
- Read more
Calibration Services:- Force, Dimension – Basic, Weighing Scale, Pressure, Acceleration and Speed, Thermal, Other.
Testing Services:- Non-Destructive Test, Concrete Test, Foundation Test, Building Material – Mechanical Test, Soil and Rock Test, Building Material – Chemical Test.